العربية | Français | English
What Is Ornamental Concrete?

What Is Ornamental Concrete?

What's decorative concrete? Ornamental concrete is basically concrete that has no real construction value. Its primarily for the purpose of bettering property worth and eye appeal. Ornamental concrete additionally makes it more simpler to maintain. Concrete may be very porous and crumbly, so these two things make it very unattractive.

Different kinds of ornamental concretes are skim coats, overlays, stamped concrete, acid staining, alkaline staining, polishing, stain and polishing, and apoxie coatings. Skim coatings are often 1/16 of an inch. They're made of Portland cement and completely different sorts of glue polymers. This would give your concrete surface a uniform and constant look. Skim coats might be stained. In addition they can have stamping accomplished to them and decorative saw cuts. Skim coatings are considered an overlay.

Stamped concrete can be considered an overlay too. These start off as a ¼ in. to ½ in. thickness. More prep work is required on the concrete before the stamped overlay is done. The thickness of this would permit the stamping to take place. This may appear to be a brick road or huge chunks of pure stones connected together. These could be stained any color and normally should have a topcoat sealer.

Acid staining provides the concrete a deep and pure look. The concrete must totally be cleaned of any glue, paint, grease, dust and left over thin set. The best way to properly put together the concrete for this is to cut the epoxy garage floor coatings surface with diamonds to a flat -hundred grit surface. This will insure the concrete is open and the acid will penetrate the surface. Since acid etches and burns the concrete, it is going to be next to impossible to additional polish out the concrete. The acid must be neutralized and a topcoat sealer would be applied. These are usually water-primarily based acrylic, solvent-based acrylic, water- based acrylic urethane and solvent acrylic urethane. The acrylics by themselves are likely to last two years and acrylic urethane tend to final 5-7 years. All 4 sealers talked about are breathable, which is Vidal for keeping you concrete in glorious condition.

Concrete staining is the simplest to do. Its especially good for model-new concrete. The prep work would involve primarily pressure washing at 2500 PSI and more than 180 degrees of scorching water. Hot water expands the concrete and permits the dust to depart so you can stain it. Cold water cracks the concrete. The best technician can stain the concrete any color.

Concrete polishing is chopping the surface of the concrete until its perfectly flat. Polish begins off at 400 grit surface. They'll go up to 3000 grit. four hundred grits are usually for stores and may have little or no maintenance. 3,000 grit would be for high finish homes.

Ecole Supérieure d'Agriculture du Kef
7119, Le Kef -Tunisie
Tél.: (+216) 78.238.038, (+216) 78.238.138
Fax : (+216) 78.238.338
Email : Cette adresse e-mail est protégée contre les robots spammeurs. Vous devez activer le JavaScript pour la visualiser.